The Casspin Closer

This device is intended to pack in the loose filling & roll the paper edge of a cigarette tube to prevent the tobacco inside from falling out and to allow the tobacco to expand equally inside of the tube.

You will easily develop your own sense of pressure & length of time that your cigarette should remain against the spinning disc.

~~~Both factors depend on the packed tubes that your rolling method produces~~~

  • Remove the black plastic end cap to install a standard 9 volt alkaline battery, insert the battery & replace the end cap
  • I have found that by adjusting my injector, tapping excess tobacco out, or tearing off the paper of the filled tube to leave the end unfilled for approx. 1/16” from the end is best.

Cig diameter 1/16th inch

  • Position the filled tube into the open end of the device
  • Press the switch to rotate the spinner

***For best results: always start the device & have it spinning before pushing a cigarette into it***

  • Apply slight pressure against the spinner, repeat as necessary to achieve the desired tip For any questions or concerns please contact us.